Operation Manual

20
EN
FR
DE
NL
ES
IT
PT
GR
NO
SE
FI
DK
RU
15. OPTIONAL PARTS
Wheel Kit Installation
(1) Check the supplied accessories
(2) Tool preparation
■
Crane or square bar (about 100mm by 100mm)
■
Pliers
■
2 sets of spanners (12mm)
(3) Installation procedures
A) Raise the generator about 100mm with the crane or square bar.
B) Install the wheel and stopper in the wheel shaft.
<Stopper section>
Install wheel shaft ⑤ into stopper ① so that wheel ② is inserted between them and fasten with pin ③.
Next, tighten wheel shaft ⑤ and stopper ① with nut ④.
<Non-stopper section>
Install wheel ② and washer ⑧ onto wheel shaft ⑤ and fasten with pin ③.
C) Check that the wheel rotates smoothly.
D) Loosen length adjustment nut ⑨ for wheel shaft ⑤ and bolt ⑩, then align the position of the hole on the
frame with the mounting hole of wheel shaft ⑤ and tighten bolt ⑥ and nut ⑦ to fi x this in place.
Tightening torque: 20 to 25N
- m (2.0 to 2.5kg - m)
E) Tighten length adjustment nut ⑨ for wheel shaft ⑤ and bolt ⑩ to fi x the length of wheel shaft ⑤.
EG671A_en_GU6838.indd 20 2010/01/18 17:14:25