Use and Care Manual

7 ENGLISH

Depth adjustment

A B

Fig.7

► 1. Locator

The depth can be adjusted by turning the locator. Turn

it in "B" direction for less depth and in "A" direction for

more depth. One full turn of the locator equals 2 mm

(1/16") change in depth.

For XSF04

3 mm (1/8")

Fig.8

► 1. Locator

For XSF05

3 mm (1/8")

Fig.9

► 1. Locator

Adjust the locator so that the distance between the tip

of the locator and the screw head is approximately 3

mm (1/8") as shown in the gures. Drive a trial screw

into your material or a piece of duplicate material. If the

depth is still not suitable for the screw, continue adjust-

ing until you obtain the proper depth setting.

Hook

CAUTION: Always remove the battery when

hanging the tool with the hook.

CAUTION: Never hook the tool at high location

or on potentially unstable surface.

Fig.10

► 1. Hook

The hook is convenient for temporarily hanging the tool.

ASSEMBLY

CAUTION: Always be sure that the tool is

switched off and the battery cartridge is removed

before carrying out any work on the tool.

Installing or removing driver bit/

socket bit

For XSF04

Fig.11

► 1. Locator