Installation Guide

Cable Layout Options:
• Afteryouhavedeterminedthelocation(s)ofyourPowerPack(s)andfixture
positions,drawlinesonyourplantoindicateyourruns.
• Keepyourrunsasshortaspossiblebyavoidinganyunnecessary
backtracking.
• Usethefollowingdiagramstohelpyoudrawthemostefficientlayoutfor
yourlightingplan.
• Usecableconnectors(8150-9801-01)toquicklyjoin2ormoreshortercables,
orchangerundirection.Onrunsover50feetorwhen10ormorelampsare
connectedtooneline,use12gaugecable,whichwillreducevoltagedrop
andproducegreaterefficiencyfromthelamps.
A. Series Installation
 Mostcommon.
B. Split the Load
 Runuptotherecommended
maximumdistanceintwoormore
directionsfromthe
PowerPack.
C. Tee Method
Allowsmoreevendistributionof
powertothecenterofarunor
toarunsomedistanceoff,i.e.
acrossadriveway.Heaviergauge
cable(10or12gauge)oradouble
runofcableshouldbeusedto
makethetee.Allcabletocable
connectionsshouldbesoldered.
D. Split Tee
Allowsrelativeuniform
distributionofpowertoboth
legs,i.e.,tobothsidesoftheyard.
Otherwise,thelayoutisthesame
asB.
E. Loop Installation
 Allowsforrelativelyuniformlight
output.*
* Polarity note: Please observe cable polarity
when using “loop” installation.
9
Choose Low Voltage Cable
P
F F F FFF
P
FF FFFF
F
F
F
F
F
F
P
FF
FF
FF
P
FF
FFFF
P
F F