Owners Manual

INTRODUCTION

THANK YOU!...

for choosing the Manley Laboratories Stereo Variable-MU Limiter Compressor . The

heart of this limiter is the variable gain vacuum tube. In tube-talk MU refers to gain

and only a few types of tubes were ever designed for variable-mu operation. This

limiting circuitry was designed by David Manley over thirty years ago. Our current

version of this unique piece combines that classic sound with the precise cleanliness

of modern componentry. The circuit is entirely differential which tends to cancel

distortion and hum. It can handle a widely varying range of input signals in a rapid-

acting manner without introducing audible coloration common in many limiters. The

Attack and Recovery (Release) times have been carefully chosen for todays

applications. These properties make this a superb compressor for both individual

tracks, mixes and final mastering.

GENERAL NOTES

LOCATION & VENTILATION

The Limiter Compressor Amplifier must be installed in a stable location with ample

ventilation. It is recommended, if this unit is rack mounted, that you allow enough

clearance on the top and bottom of the unit such that constant movement of air can

flow through the ventilation holes. There are 8 tubes inside this unit so it does run

quite hot. Good ventilation is definitely encouraged.

WATER & MOISTURE

As with any electrical equipment, this unit should not be used near water or

moisture.

SPECIAL NOTES

Tubes may become loose during transit. Straighten and press down each tube before

plugging this unit into the mains socket. Furthermore, don't touch the tubes after the

unit has been switched on, the tubes become very hot during operation and should

only be handled after the power has been turned off and the tubes have cooled.

WARNING!

TO PREVENT THE RISK OF ELECTRIC SHOCK

DO NOT OPEN THE CABINET

REFER SERVICING TO

QUALIFIED PERSONNEL