Use And Care Manual
Mansfield Plumbing Products, LLC
www.mansfieldplumbing.com
150 East First Street, Perrysville, OH • 877-850-3060 • custsrvs@mansfieldplumbing.com
© 2020 Mansfield Plumbing Products, LLC
REV 2/2020
For protection during shipping and handling, the push buon
flush actuator for this tank is not installed at the factory.
INSTALLATION INSTRUCTIONS:
1. Remove the protective packaging from the push
buon assembly and remove the lock nut.
2. Feed the push buon actuator rods through the top of
the hole in the tank lid, rotating the assembly as needed
to ensure the larger/full flush buon is on the left and the
assembly is square with the back of the tank.
3. Hold the assembly in position and thread the lock
nut onto the assembly from the underside of the tank lid.
Hand tighten until secure.
ATTENTION INSTALLER!
Lock Nut
When properly installed:
• the larger buon will be on the left
• the buon actuator rods will line up with the corresponding
buons on the flush tower (marked with a full circle and a half circle)
• the buon will be oriented perpendicularly to the back of the tank.
Reduced FlushFull Flush