Use and Care Manual
12 Manuel de l’utilisateur
INFORMATIONS SUR LE CHARGEUR (SUITE)
Brancher la che du chargeur dans la
prise de courant. Le voyant ROUGE
s’allume en continu.
Voyant ROUGE
ALLUMÉ
Placer la batterie dans le chargeur en la glissant à
fond vers l’avant.
Le chargeur Mantis fait aussi fonction d’outil de
diagnostic. Ses voyants s’allument suivant des
motifs spéciques pour indiquer l’état actuel de la
batterie. Voir la table ci-dessous.
VOYANT INDICATEUR DU CHARGEUR
ROUGE ALLUMÉ en continu, VERT CLIGNOTANT La batterie se charge
VERT ALLUMÉ en continu, ROUGE ÉTEINT
La batterie est complètement chargée. Retirer la batterie du
chargeur.
ROUGE et VERT tous deux CLIGNOTANTS
Température anormale. La batterie est soit trop chaude, soit trop
froide
Voyant VERT ÉTEINT, voyant ROUGE
CLIGNOTANT
Problème de batterie. La retirer et la changer. Pour toute
assistance, appeler le service après-vente Mantis au 1-800-366-
6268.
• Une fois la charge terminée, glisser la batterie vers l’arrière pour la retirer du chargeur.
REMARQUE : La durée habituelle pour atteindre une pleine charge est d’environ 100 minutes.
MISE EN PLACE DE LA BATTERIE
Ouvrir le capot du logement de batterie. Pour cela, appuyer sur loquet
de verrouillage (rep. C) comme sur la Fig. 1 et relever le capot. Engager
ensuite la batterie dans les supports, comme sur la Fig. 2, et l’enfoncer
jusqu’à ce qu’elle s’enclenche (déclic). Pour retirer la batterie, appuyer
sur le bouton de dégagement de la batterie (rep. D, Fig. 3) et la glisser
hors du logement.
CHARGER UNE BATTERIE CHAUDE OU FROIDE
Les batteries fonctionnent sur une large plage de température, mais cela ne signie pas
qu’elles peuvent aussi être chargées dans les mêmes conditions. Le processus de charge est
plus délicat que la décharge et suppose des précautions particulières. Les froids extrêmes
et les fortes chaleurs réduisent la capacité d’accumulation, c’est pourquoi la batterie doit être
amenée à une température modérée avant d’être chargée.
Si les deux voyants ROUGE et VERT du chargeur clignotent, cela signie que la température
de la batterie est en dehors de la plage de charge. Une fois que la batterie est dans la plage
acceptable, la charge s’effectue normalement. Les batteries chaudes ou froides peuvent
prendre plus de temps pour se charger.
TO CHARGE
Insert the plug of the charger into the wall receptacle.The top red light will
illuminate and stay red.See figure .
Place the battery pack into the charger by sliding the pack
as shown in figure 8 to lock it into position .
The bottom light will Illuminate green to indicate that the battery is charging.
The bottom green (charging) light will blink continuously and the top red light
remaining ON continuously, indicating that the charging process has started.
NOTE: Typical time required to reach a full charge is around 100 minutes.
NOTE: If the top light remains red while the bottom light alternately flashes red and green, this indicates a
temperature abnormality (i.e. that the battery pack is either too hot or too cold). If t here is only a red blinking light, this indicates that something is
wrong with the battery. Contact Schiller customer service center at 1-800-366-6268 for assistance.
If th e charging light indicator alternately blinks red and green or the light indicator does not come on at all, check that the battery pack is fully seated
into the bay. Remove the pack and reinsert. If the problem persists, contact the Schiller customer service center at 1-800-366-6268 for assistance.
INATALLING THE BATTERY
Open the battery cover. This is done by pressing the lock release (Item c) as shown in Fig. 1 and swinging up the cover. Then connect the ba ttery
into the mounts as shown in Fig. 2 and push them forward until you hear the batteries engage. Push the button Fig.3/item D and then ta ke out the
battery when finish using.
Important!
The battery must always be fully charged before use. Close the battery cover by swinging it down, and make sure that it latches in place correctly.
Cordless Tiller Operation
INTENDED USE
The cordless tiller is designed for small gardens and flower beds, this cordless tiller effectively loosens and turns over new soil. It may also be used
to mix coarse soil with fertilizer, peat, and compost. This product may not be used to till extremely dry or wet soil.The use of this product in rain or
wet conditions is prohibited.
For safety reasons, it is essential to read the entire instruction manual before first use and to observe all the instructions contained within this
manual.
Fig.1
D
Fig. 2
C
Fig. 3
TO CHARGE
Insert the plug of the charger into the wall receptacle.The top red light will
illuminate and stay red.See figure .
Place the battery pack into the charger by sliding the pack
as shown in figure 8 to lock it into position .
The bottom light will Illuminate green to indicate that the battery is charging.
The bottom green (charging) light will blink continuously and the top red light
remaining ON continuously, indicating that the charging process has started.
NOTE: Typical time required to reach a full charge is around 100 minutes.
NOTE: If the top light remains red while the bottom light alternately flashes red and green, this indicates a
temperature abnormality (i.e. that the battery pack is either too hot or too cold). If t here is only a red blinking light, this indicates that something is
wrong with the battery. Contact Schiller customer service center at 1-800-366-6268 for assistance.
If th e charging light indicator alternately blinks red and green or the light indicator does not come on at all, check that the battery pack is fully seated
into the bay. Remove the pack and reinsert. If the problem persists, contact the Schiller customer service center at 1-800-366-6268 for assistance.
INATALLING THE BATTERY
Open the battery cover. This is done by pressing the lock release (Item c) as shown in Fig. 1 and swinging up the cover. Then connect the ba ttery
into the mounts as shown in Fig. 2 and push them forward until you hear the batteries engage. Push the button Fig.3/item D and then ta ke out the
battery when finish using.
Important!
The battery must always be fully charged before use. Close the battery cover by swinging it down, and make sure that it latches in place correctly.
Cordless Tiller Operation
INTENDED USE
The cordless tiller is designed for small gardens and flower beds, this cordless tiller effectively loosens and turns over new soil. It may also be used
to mix coarse soil with fertilizer, peat, and compost. This product may not be used to till extremely dry or wet soil.The use of this product in rain or
wet conditions is prohibited.
For safety reasons, it is essential to read the entire instruction manual before first use and to observe all the instructions contained within this
manual.
Fig.1
D
Fig. 2
C
Fig. 3
TO CHARGE
Insert the plug of the charger into the wall receptacle.The top red light will
illuminate and stay red.See figure .
Place the battery pack into the charger by sliding the pack
as shown in figure 8 to lock it into position .
The bottom light will Illuminate green to indicate that the battery is charging.
The bottom green (charging) light will blink continuously and the top red light
remaining ON continuously, indicating that the charging process has started.
NOTE: Typical time required to reach a full charge is around 100 minutes.
NOTE: If the top light remains red while the bottom light alternately flashes red and green, this indicates a
temperature abnormality (i.e. that the battery pack is either too hot or too cold). If t here is only a red blinking light, this indicates that something is
wrong with the battery. Contact Schiller customer service center at 1-800-366-6268 for assistance.
If th e charging light indicator alternately blinks red and green or the light indicator does not come on at all, check that the battery pack is fully seated
into the bay. Remove the pack and reinsert. If the problem persists, contact the Schiller customer service center at 1-800-366-6268 for assistance.
INATALLING THE BATTERY
Open the battery cover. This is done by pressing the lock release (Item c) as shown in Fig. 1 and swinging up the cover. Then connect the ba ttery
into the mounts as shown in Fig. 2 and push them forward until you hear the batteries engage. Push the button Fig.3/item D and then ta ke out the
battery when finish using.
Important!
The battery must always be fully charged before use. Close the battery cover by swinging it down, and make sure that it latches in place correctly.
Cordless Tiller Operation
INTENDED USE
The cordless tiller is designed for small gardens and flower beds, this cordless tiller effectively loosens and turns over new soil. It may also be used
to mix coarse soil with fertilizer, peat, and compost. This product may not be used to till extremely dry or wet soil.The use of this product in rain or
wet conditions is prohibited.
For safety reasons, it is essential to read the entire instruction manual before first use and to observe all the instructions contained within this
manual.
Fig.1
D
Fig. 2
C
Fig. 3
TO CHARGE
Insert the plug of the charger into the wall receptacle.The top red light will
illuminate and stay red.See figure .
Place the battery pack into the charger by sliding the pack
as shown in figure 8 to lock it into position .
The bottom light will Illuminate green to indicate that the battery is charging.
The bottom green (charging) light will blink continuously and the top red light
remaining ON continuously, indicating that the charging process has started.
NOTE: Typical time required to reach a full charge is around 100 minutes.
NOTE: If the top light remains red while the bottom light alternately flashes red and green, this indicates a
temperature abnormality (i.e. that the battery pack is either too hot or too cold). If t here is only a red blinking light, this indicates that something is
wrong with the battery. Contact Schiller customer service center at 1-800-366-6268 for assistance.
If th e charging light indicator alternately blinks red and green or the light indicator does not come on at all, check that the battery pack is fully seated
into the bay. Remove the pack and reinsert. If the problem persists, contact the Schiller customer service center at 1-800-366-6268 for assistance.
INATALLING THE BATTERY
Open the battery cover. This is done by pressing the lock release (Item c) as shown in Fig. 1 and swinging up the cover. Then connect the ba ttery
into the mounts as shown in Fig. 2 and push them forward until you hear the batteries engage. Push the button Fig.3/item D and then ta ke out the
battery when finish using.
Important!
The battery must always be fully charged before use. Close the battery cover by swinging it down, and make sure that it latches in place correctly.
Cordless Tiller Operation
INTENDED USE
The cordless tiller is designed for small gardens and flower beds, this cordless tiller effectively loosens and turns over new soil. It may also be used
to mix coarse soil with fertilizer, peat, and compost. This product may not be used to till extremely dry or wet soil.The use of this product in rain or
wet conditions is prohibited.
For safety reasons, it is essential to read the entire instruction manual before first use and to observe all the instructions contained within this
manual.
Fig.1
D
Fig. 2
C
Fig. 3
TO CHARGE
Insert the plug of the charger into the wall receptacle.The top red light will
illuminate and stay red.See figure .
Place the battery pack into the charger by sliding the pack
as shown in figure 8 to lock it into position .
The bottom light will Illuminate green to indicate that the battery is charging.
The bottom green (charging) light will blink continuously and the top red light
remaining ON continuously, indicating that the charging process has started.
NOTE: Typical time required to reach a full charge is around 100 minutes.
NOTE: If the top light remains red while the bottom light alternately flashes red and green, this indicates a
temperature abnormality (i.e. that the battery pack is either too hot or too cold). If t here is only a red blinking light, this indicates that something is
wrong with the battery. Contact Schiller customer service center at 1-800-366-6268 for assistance.
If th e charging light indicator alternately blinks red and green or the light indicator does not come on at all, check that the battery pack is fully seated
into the bay. Remove the pack and reinsert. If the problem persists, contact the Schiller customer service center at 1-800-366-6268 for assistance.
INATALLING THE BATTERY
Open the battery cover. This is done by pressing the lock release (Item c) as shown in Fig. 1 and swinging up the cover. Then connect the ba ttery
into the mounts as shown in Fig. 2 and push them forward until you hear the batteries engage. Push the button Fig.3/item D and then ta ke out the
battery when finish using.
Important!
The battery must always be fully charged before use. Close the battery cover by swinging it down, and make sure that it latches in place correctly.
Cordless Tiller Operation
INTENDED USE
The cordless tiller is designed for small gardens and flower beds, this cordless tiller effectively loosens and turns over new soil. It may also be used
to mix coarse soil with fertilizer, peat, and compost. This product may not be used to till extremely dry or wet soil.The use of this product in rain or
wet conditions is prohibited.
For safety reasons, it is essential to read the entire instruction manual before first use and to observe all the instructions contained within this
manual.
Fig.1
D
Fig. 2
C
Fig. 3
La batterie doit toujours être complètement chargée avant
utilisation. Rabattre le capot du logement de batterie pour
le fermer et s’assurer qu’il s’enclenche correctement.
ATTENTION!
État de charge des batteries lithium-ion
Température
de la batterie
Voyants indicateurs État de charge
Trop chaude
ROUGE et VERT tous
deux clignotants
Pas de charge
Plage normale
ROUGE ALLUMÉ
en continu, VERT
CLIGNOTANT
Charge normale
Trop froide
ROUGE et VERT tous
deux clignotants
Pas de charge