Operation Manual

6
BASIC
CONNECTIONS
BASIC
OPERATIONS
ADVANCED
CONNECTIONS
ADVANCED
OPERATIONS
TROUBLESHOOTING
NAMES AND
FUNCTIONS
OTHERS
NAMES AND
FUNCTIONS
BASIC
CONNECTIONS
ENGLISH
NAMES AND FUNCTIONS
REAR PANEL
REMOTE CONTROL
REMOTE CONTROL
DIGITAL AUDIO OUT
DIGITAL AUDIO OUT
ANALOG OUT
ANALOG OUT
EXTERNAL
EXTERNAL
INTERNAL
INTERNAL
OPTICAL
OPTICAL
COAXIAL
COAXIAL
IN
IN
OUT
OUT
LR
AC IN
AC IN
yr tq w e
q ANALOG OUT connectors
The music signals during play are output from these
connectors.
w DIGITAL AUDIO OUT COAXIAL
connector
The music signals during play are output digitally
from this coaxial output connector.
Note
Digital signals are not output at some settings.
For details, see “DIGITAL OUTPUT OFF” and
“AUDIO EX SELECTION” (See page 13).
e DIGITAL AUDIO OUT OPTICAL
connector
The music signals during play are output digitally
from this optical output connector.
Note
Digital signals are not output at some settings.
For details, see “DIGITAL OUTPUT OFF” and
“AUDIO EX SELECTION” (See page 13).
r REMOTE CONTROL IN and OUT
connectors
Using the supplied remote control connecting cable,
these connectors enable this unit to be connected
to a Marantz component equipped with remote
control connectors. These connections make it
possible to control an entire system that centers on
the amplifi er or other such component.
t EXTERNAL/INTERNAL switch
The switch is set to INTERNAL, when fi rst purchased,
enabling the unit’s built-in signal reception window
to be used.
Before using the supplied connecting cable to make
the connection between the unit and the remote
control connectors on a Marantz equipment, set the
switch to EXTERNAL.
Note
Signals cannot be received from the remote
controller if the switch is kept at EXTERNAL when
the unit is to be used on its own.
y Power cord connector socket
Use the supplied power cord to connect to a
standard household power supply outlet.
Connect the unit so that the power cord can
be removed easily as a precaution against
possible accidents.
BASIC CONNECTIONS
CONNECTING TO AN AMPLIFIER
REMOT
REMOTE CONTROL
DIGITAL AUDIO OUT
DIGITAL AUDIO OUT
ANALOG OUT
ANALOG OUT
OPTICAL
OPTICAL
COAXIAL
COAXIAL
I
NIN
O
UOUT
LR
(Red) (White)
Audio connecting cable (supplied)
To the CD input
connectors
Amplifi er
Notes
•Do not connect this unit and other components
to mains power until all connections between
components have been completed.
• Insert all plugs and connectors securely.
Incomplete connections may make noise.
• Be sure to connect the left and right channels
properly.
• Be sure to connect input and output properly.
• Refer to the instructions for each component that
is connected to this unit.
• Do not bind audio/video connection cables with
power cord and speaker cables this will result in
generating a hum or other noise.
• Do not connect the unit to the PHONO input
connectors on the amplifi er.
CONNECTING THE POWER
SUPPLY
1. Plug the power cord into AC IN jack on the
rear panel.
AC IN
2. Plug the power cord into an AC outlet.
3. Turn on the power switch of the audio unit
(amplifi er, etc.) that is connected with this
unit. Set the selector on the connected unit
to this unit.
CD6003_N_01_Eng.indd 6CD6003_N_01_Eng.indd 6 09.5.29 4:00:14 PM09.5.29 4:00:14 PM