Owner`s manual

Network
To use this unit by connecting it to a home network (LAN), you must configure network settings.
If you set up your home network via DHCP, set “DHCP” to “On” (use the default setting). This allows this unit to use your home network.
If you assign an IP address for each device, you must use the “IP Address” setting to assign an IP address to this unit and enter the information about your
home network such as the gateway address and subnet mask.
Network Information
Displays network information.
Friendly Name / DHCPOn or Off / IP Address / MAC Address
Network Control
Enables network communication in standby power mode.
On:
Network is on during standby. Main unit
operable with a network compatible
controller.
Off (Default): Suspend network function during standby.
Set to “On” when using the web control function or a network compatible controller.
NOTE
When “Network Control” is set to “On”, it consumes more standby power.
Friendly Name
The Friendly Name is the name of this unit displayed on the network.
o
Friendly Name
When you press ENTER, you can change the Friendly Name
according to your preferences.
0
Up to 63 characters can be input.
0
For character input, see “Inputting characters” (v
p. 80).
0
The default Friendly Name on first use is “NA8005”.
o
Default
Restores Friendly Name, which you had changed, to the default
setting.
Contents
Connections Playback Settings Tips Appendix
85
Front panel Rear panel
Remote control
unit
Index