User guide

9
ENGLISHFRANÇAIS
DEUTSCHNEDERLANDSESPAÑOLITALIANOPORTUGUÊSSVENSKADANSK
USING THE REMOTE CONTROL UNIT
When operating the remote control unit (RC8000PM), point its trans-
mitter directly at the remote sensor, which is located on the front of
the amplifier. Make sure the remote control unit is no further than
about 5 meters from the remote sensor. Remote control operation
may not be possible if the remote control unit’s transmitter is not
pointing directly at the remote sensor, or if there is an obstruction
between the transmitter and sensor.
REMOTE CONTROL UNIT BATTERIES
Remote control unit batteries should last for about one year under
normal conditions. Replace batteries as soon as possible whenever
they show signs of running low. Also, be sure to remove the batteries
if you do not plan to use the remote control unit for a long time.
TO LOAD REMOTE CONTROL UNIT BATTERIES
(1) Remove the battery compartment cover.
(2) Load two batteries, making sure their positive (+) and
negative (–) ends are facing correctly.
(3) Slide the battery compartment cover back into place and
press until it clicks shut.
Remote Control Operating Range
Back of Remote Control Unit
(RC8000PM)
Remote Control Unit RC8000PM
Two AA-size (R6) (UM-3) batteries
Approximately 5 meters
60°
BUTTON NAME FUNCTION
Play
Fast-forward
Rewind
None
Stop
Pause
OPEN/CLOSE Eject
+ Next
– Previous
A, F/P Edit
B, –/–– Enter
MODE Monitor
MEMO Store
TEXT (MODE 1) None
TIME (MODE 2) Time
Next
Previous
SCROLL Scroll
CANCEL Delete
MD BUTTON
The following are the functions assigned to control buttons after the
MD amplifier source button is pressed.