Owners manual

Revision 1.5 Page 9
®®
Received NMEA 2000 PGN Transmitted NMEA 0183 Sentence Transmit
Number Description Acronym Description Default
126992 System Time ZDA Time & Date On
127245 Rudder RSA Rudder Sensor Angle On
127250 Vessel Heading HDG/HDT Heading, Dev. & Var. / Heading, True On
127251 Rate of Turn ROT Rate of Turn On
127257 Attitude PMAROUT Proprietary Maretron Sentence On
127488 Engine Parameters, Rapid
Update
RPM/
PMAREPR
Revolutions/
Proprietary Maretron Sentence
On
127489 Engine Parameters,
Dynamic
PMAREPD Proprietary Maretron Sentence On
127505 Fluid Level XDR Trandducer Measurement On
127508 Battery Status XDR Transducer Measurement On
128259 Speed VBW/VHW Dual Ground/Water Speed /
Water Speed and Heading
On
128267 Water Depth DPT Depth On
128275 Distance Log VLW Dual Ground/Water Distance On
129025 Position, Rapid Update GLL Geographic Position – Latitude/Longitude Off
129026 COG & SOG, Rapid Update VTG Course Over Ground and Ground Speed On
129029 GNSS Position Data GGA/GNS GPS Fix Data / GNSS Fix Data On
129029 GNSS Position Data GLL Geographic Position – Latitude/Longitude On
129033 Time & Date ZDA Time & Date On
129539 GNSS DOPs GSA GNSS DOP and Active Satellites Off
129540 GNSS Sats in View GSV GNSS Satellites in View On
129540 GNSS Sats in View GSA GNSS DOP and Active Satellites On
130306 Wind Data MWD/MWV Wind Dir. & Speed / Wind Speed & Angle On
130310 Environmental Parameters MTW Water Temperature On
130310 Environmental Parameters XDR Transducer Measurement On
130311 Environmental Parameters MTW Water Temperature On
130311 Environmental Parameters XDR Transducer Measurement On
130576 Small Craft Status XDR Transducer Measurement On
Table 1 – NMEA 2000® to NMEA 0183 Sentence Translations
The easiest way to change or configure these translations is by the included GWUtilities
program whose use is described in Section 2.6.1.1 below.
2.6.1.1 GWUtilities Configuration Program
2.6.1.1.1 What is GWUtilities?
GWUtilities is a program that allows a user to configure Maretron gateway products. Normally,
the translations programmed into the gateway at the factory should be satisfactory, but a
particular application may require that some of the normally enabled translations be disabled.
In addition, gateway products contain additional translations that are not enabled at the factory
and may need to be enabled for use with particular software.