Warranty

- Do NOT install the water heater in a sealed room or in a room with poor air circulation.
- You MUST install the exhaust pipe to properly discharge the exhaust gases.
- Do NOT block the exhaust pipe or the air inlet at any time. This can cause incomplete
combustion and can lead to gas poisoning.
- When the water heater is in use, do NOT touch the body of the heater. Touch the
knobs only, as the body of the heater can become very hot to the the touch.
- Prevent scalds! While using the water heater, always check the water temperature and
adjust as needed before use.
WARNING! There is water contained in the coils of your water heater at all times. If your
water heater is exposed to freezing temperatures, the water in the coils could freeze,
causing a break in the heat exchanger of the unit, or the supply and return lines. This
kind of damage will result in water running freely into the space where the water
heater is located, with can cause ooding. If your water heater is installed in a geo-
graphic location that sees very low sustained temperatures, you MUST install a back-
ow preventer on your heater's vent pipe. This will ensure that cold air cannot fall
down into the water heater and cause freezing damage. DO NOT install this water
heater where it may be subjected to a freeze. If your water heater is in an area where
freezing is a possibility, you must turn o the water to the heater and drain it of any
water by using the valve stem at the bottom of the unit and disconnecting the warm
water line. Leave the valve stem and the warm water line disconnected until you
1. Water - controlled automatic ignition:
When water ow is detected, heating is provided immediately with a double ignition
device. The ame is sensed by ions. This sensitive control makes the unit easy and
convenient to operate.
2. Auto - cut off protection:
The auto-cut-o protection will shut o the gas supply immediately if the ame goes
out for any reason.
3. Energy savings:
The advanced combustion system comes with a Winter/Summer switch. In winter, when
incoming water temperatures are lower, the winter setting increases the size of the
ame to compensate with extra heating. In summer, when incoming water
temperatures are higher, the summer setting reduces the ame.This provides more
comfort and energy savings in the form of lower gas consumption in warmer months.
FUNCTION AND FEATURES
06