Use and Care Manual

Hold the back bracket hanger in position against the wall in the desired hanging

location. Check to make sure that the bracket is level. Mark the wall where the mount-

ing holes should be located. Drill holes of¼" diameter in the marked locations. If you

are on a stud, screw the bracket directly into the wal I. If you are not on a stud, insert

the plastic anchor in the hole, and secure the bracket using the screws supplied

Remove (4) screws and washers (Fig 11) from the unit to free the front cover. Carefully

lift the front cover o the unit a few inches. Disengage the ribbon cable connecting the

front cover LCD panel to the main control board or the unit (Fig 12). Remove the cover

completely.

Please note: If LCD connection cable cannot be disengaged, simply set the front cover

Fig. 10

Fig. 11