Installation Guide

-This water heater must only be used with
the following water supply system conditions:
-With clean, potable water free of corrosive
chemicals, sand, dirt, or other contaminants.
-With inlet water temperatures above
32℉(0℃), but not exceeding 118℉(48℃).
-Do not reverse the hot and cold water
connections. The water heater will not
operate.
·Even when drained properly, a small
amount of water will remain in the
water heater. In cold weather conditions,
this water can be frozen. If this happens,
allow the defrost protection on the heater
at least 30 minutes to melt the frozen
water or the water heater may not
work properly.
Chart