How to Guide

Working with gas can be dangerous. If you are not familiar with local building codes

and basic gas plumbing practices please employ a professional to install your water

heater.

1. Securely mount your water heater to the wall in an appropriate location using the

supplied hardware.

Install the venting (4" for the 5L) per local building codes and the instructions

supplied.

3. Connect the gas lines (all connections are ½"). Use yellow Teon tape at threaded

connections. Check carefully for gas leaks using soapy water and correct as necessary

before proceeding further.

4. Connect the water lines (all connections are ½"). Use ½" or ¾" pipe or tubing for the

water supply and return. If water pressure or ow rates are questionable use ¾" lines

to ensure maximum ow. You MUST use copper, CPVC or appliance tubing intended

for use in hot water applications for all hot water lines.

5. Check for and correct water leaks as necessary.

6. Install the batteries in the battery compartment. Be sure the polarity of the batter-

ies

is correct.

7. Turn on the faucet and adjust the water and gas settings on the water heater as

needed for your specic environment and comfort. **USE CAUTION NOT TO GET

SCALDED WHILE ADJUSTING YOUR SETTINGS** Remember that more water ow will

usually result in less heating, and vice versa. Higher gas settings result in more heat-

ing, and vice versa.

8. Begin enjoying instant, energy ecient hot water for years to come!

Disclaimer: This document is intended as a quick reference only and does not contain

all of the important safety warnings and other information necessary to safely oper-

te your heater. For a complete list of safety warnings and instructions please

reference the instruction manual before operating your water heater.

WARNING

POWER GAS MODELS

QUICK START GUIDE