Owner's Manual

12
N
0
5805 / N
0
5802 INTEGRATED AMPLIFIER / OWNER’S MANUAL
CONTROL
The N
0
5805 / N
0
5802 was designed for elegant simplicity and
ergonomics. Therefore the knobs perform a variety of functions
depending on the operating mode. There are two modes of
operation, Listening mode and Setup mode, and three modes of
standby, Green, Power-save, and Normal.
Please read this section carefully and take the time to learn
the operating modes. We strongly recommended you turn
your volume very low or all the way down before entering the
setup mode.
Standby button and LED: Press this button to put the N
0
5805 /
N
0
5802 into and out of the Standby mode. The LED illuminates
steady RED when the unit is On. When the unit is in the standby
state, the LED flashes slowly.
Input/Select knob: When in listening mode rotate this knob
to select the desired source signal to send to all outputs. The
front panel display indicates the name and volume level of the
selected input. (Note: The Select knob will bypass any input
for which the Input Name parameter is set to “Disabled” in the
setup mode.) When in setup mode, turning this knob will scroll
through menu choices.
IR receiver: The IR receiver receives commands from the
included remote control when the rear-panel IR Input is not
being used.
Menu button: Press this button to display the Setup menu,
which you can use to customize the N
0
5805 / N
0
5802 to suit
your other system components and individual preferences. This
button performs a "Back" function when more than two levels
deep into menu parameters.
Headphone output: Connect any headphone equipped with a
1/4" tip/ring/sleeve “Phone” plug or adaptor. When headphones
are plugged in the speaker and line outputs are muted.
Volume/Scroll/Enter: This knob is a rotary encoder and switch.
When in listening mode, this knob acts as a volume control.
Turn this knob to adjust the volume level. When the setup mode
is activated by pressing the
Menu button, this knob/button
scrolls through the setting options and acts to select or deselect
the displayed choice when pushed inward. The Enter button
displays the sampling rate for digital inputs when in listening
mode. If "MQA" or "MQA." is displayed along with the sampling
rate, it indicates that the product is decoding and playing an
MQA stream or file. "MQA." indicates it is playing an MQA Studio
file, which has either been approved in the studio by the artist/
producer or has been verified by the copyright owner.
Front Panel Display: This 32-character alphanumeric display
provides information about the N
0
5805 / N
0
5802’s operating
status. During normal operation, it indicates the name and
volume level of the selected input.
FRONT-PANEL OVERVIEW
Input/ Select Knob IR Receiver Volume/Scroll/Enter