Owner's Manual

16
N
0
5805 / N
0
5802 INTEGRATED AMPLIFIER / OWNER’S MANUAL
SETUP
SETUP MENU NAVIGATION
The Setup menus on your Mark Levinson integrated amplifier
allow you to customize and configure the unit for higher
performance, power economy, and convenience.
There are two means for accessing and navigating the
Setup
menu: via the front panel display using the front panel or
remote control, or via the Browser Setup Page on a networked
browser-enabled device. Regardless of the method you choose,
the procedures are similar.
Remote and Front Panel Operation
Press the
Menu button to display the Setup menu on the
integrated amplifier’s front-panel display. When the
Setup
menu is active, use the Select knob to scroll through options,
the
Select Knob on the front panel or Enter button on the
remote to select and deselect options, and the
Volume knob to
adjust parameters. To move back a level in the menu structure
(or exit the
Setup menu), press the Menu button repeatedly until
the desired menu appears in the display.
Browser Setup Page (BSP) Operation
Connect your Mark Levinson integrated amplifier to a PC or
tablet via your home network and open a browser. Simply type
in your units IP address into a major browser connected to the
same network as the
N
0
5805 / N
0
5802 , and the BSP will appear
in a few moments. Network speed and quality of the connection
will affect the response time of the BSP (see page 15 for
instructions on finding the IP address on your
N
0
5805 / N
0
5802 ).
The
Home screen displays the current active input name near
the top of the screen, the current volume level in the slider and
navigation controls. In addition there is a SW update button
which provides a one touch update from our FTP site. CAUTION:
If you choose to update the SW, DO NOT interrupt the process.
Click the
Menu icon to activate the setup mode. When the Setup
menu is active, use the Left < and Right > arrows to scroll
through options, use the Enter icon to select and deselect
options, and the up
�
and down
ˇ
arrows to adjust parameters.
To move back a level in the menu structure (or exit the
Setup
menu), click the Menu button repeatedly until the desired menu
appears in the display.
SETUP