Owner's Manual

21
N
0
5805 / N
0
5802 INTEGRATED AMPLIFIER / OWNER’S MANUAL
VOLUME
Setup Menu Volume
Input
Max-XXX
Volume
Mute=XXX
Power
Turn On=XXX
Display
Taper=XXX
Advanced
The Volume settings let you customize the action of the N
0
5805
/ N
0
5802 Volume and Mute functions.
Max Vol: This setting determines the maximum volume level
setting in 0.5dB increments between 40.0dB and 80.0dB. The
factory default maximum volume is 80.0dB. Set this value to
the volume slightly below where your speakers start to distort
audibly.
Mute: This setting lets you set the amount of Speaker output
and Line output level attenuation that occurs when the Mute
button is engaged, in 0.5dB increments between –10dB and
–80.0dB. The factory default mute attenuation is –40dB.
Turn On: This control lets you set the initial volume upon turn-
on. Choose a turn-on volume level in 0.5dB increments between
10.0dB and 60.0dB. The factory default setting is 40.0dB.
Last: When selected, sets the turn-on volume level to the last
used volume setting.
CAUTION: Setting the Turn On parameter to “Last” can result
in louder-than-expected power-up volume if the N
O
5805
/ N
0
5802 was set to a high volume level setting when last
powered down.
Taper: This setting lets you choose the desired taper for the
volume control from the following options:
Mode 1: The faster you rotate the volume knob, the more
quickly the volume will change. Slowly turning the knob
slows the rate the volume changes, allowing you to make
precise adjustments in the listening level.
Mode 2: Similar to Mode 1, with a “faster” response curve,
with more gain change for a similar range of knob travel.
Mode 3: When increasing the volume the volume changes
quickly through the low volume range, and then decelerate
in the higher range, for precision adjustments. When
decreasing the volume the control works oppositely,
changing quickly through the high volume range and
decelerating in the lower range.
SETUP