Owner's Manual

24
N
0
5805 / N
0
5802 INTEGRATED AMPLIFIER / OWNER’S MANUAL
Update: Lets you update your N
0
5805 / N
0
5802’s firmware,
either from a drive inserted in the rear-panel USB port or via
a web browser. (For browser connection guidance see Browser
Setup Page (BSP) on page 25.)
ENET: Select this if your N
0
5805 / N
0
5802 is connected to
a home network. The unit will access the Mark Levinson
server and download the latest firmware. The download and
installation process takes at least 15 minutes and should not
be interrupted. The unit will cycle through several stages of
downloading and installing new operating files and go in and
out of
Standby mode. BE PATIENT. You will know when the
process is almost over when you see “Booting…” followed by
“Starting N
0
5805…” followed by “Firmware Version [number]…”
followed by “Starting..” The unit will then enter
Standby mode.
Wait for the
Standby LED to start blinking before attempting to
turn on the unit. BE PATIENT.
(If you select ENET when the unit is not connected to a network
the unit‘s display shows “Failed” to remind you to connect to a
network and begin downloading the firmware.)
To update via a flash drive:
1. Download the firmware file from the product page at
MarkLevinson.com and save it to a USB drive
2. Select USB and press Enter
3. The N
0
5805 / N
0
5802 will read the USB drive. (The display
will show “Check Update” while the drive is being read.)
4. When the N
0
5805 / N
0
5802 finds a valid firmware file on
the drive, the display will show “Downloading.”
• If the N
0
5805 / N
0
5802 does not find a valid firmware
file on the drive, the display will show “Not Available.”
The installation process takes at least 15 minutes and should
not be interrupted. The unit will cycle through several stages
of downloading and installing new operating files and go in
and out of
Standby mode. BE PATIENT. You will know when the
process is almost over when you see “Booting…” followed by
“Starting N
0
5805 (or N
0
5802)…” followed by “Firmware Version
[number]…” followed by “Starting..” The unit will then enter
Standby mode. Wait for the Standby LED to start blinking before
attempting to turn on the unit. BE PATIENT.
SETUP