Nº33H MONAURAL POWER AMPLIFIER
Nº33H MONAURAL POWER AMPLIFIER from input to output. These are taken from a single 3.417 kVA custom transformer, using multiple taps to maintain the symmetrical nature of the two bipolar supplies. Since each amplifier is monaural, you can count on symmetry at the Each monaural Nº33H weighs in at 175 pounds transformer for the noninverting and inverting (over 80 kg) and takes advantage of a vertically sides of the same signal.
stages. The result is the purest possible power for other Mark Levinson amplifiers, will shut them- these sensitive stages. selves down if they sense any of a number of fault conditions which could cause damage to either “Double” Balanced Voltage Gain Stages: The themselves or to the loudspeakers.
Nº33H Monaural Power Amplifier Rated power output: Frequency response: Signal-to-noise ratio (main outputs): Voltage gain: Input impedance: Input sensitivity: Output impedance: Power consumption: Mains voltage: Connector complement: Overall dimensions: Shipping weight: 150W/ch continuous rms power @ 8Ω 300W/ch continuous rms power @ 4Ω The above power ratings measured as continuous (rms) power from 20Hz–20kHz with no more than 0.
Mark Levinson® is a registered trademark of Harman International Industries, Incorporated. Not responsible for typographic errors. Part # 072-17290 3 Oak Park, Bedford, MA 01730-1413 USA Te l : 7 8 1 - 2 8 0 - 0 3 0 0 | F a x : 7 8 1 - 2 8 0 - 0 4 9 0 www.mar klevinson.
