User Manual

536 MONAURAL / N

534 DUAL-MONAURAL AMPLIFIER / OWNER’S MANUAL

ENGLISH

CONNECTIONS

CAUTION: Before making connections, make sure the

amplifier and all associated components are powered off and

disconnected from electrical outlets.

1. Connect your preamplifier or source device with volume

control to either the amplifier’s Balanced (XLR) or Single

Ended (RCA) input connectors. Mark Levinson recommends

using the Balanced input connectors if your preamplifier or

source equipment has balanced output connectors.

2. Switch the Ground Switch(es) to the position closest to the

inputs you have connected. Check that the switch is all the

way to the end of its travel path.

3. Connect speaker cables to the binding posts of the amplifier(s)

and loudspeakers.

4. Connect the supplied power cable to the amplifier’s AC

Mains connector and into an electrical outlet. Turn the rear-

panel Power switch on the amplifier to On, and turn on all

associated components.

5. Press the front-panel Standby button on each component in

the system.

6. Start playback from the connected source and adjust the

volume level slowly. It is best to start low and turn up to avoid

unintentionally damaging your equipment. Begin playing the

selected source device.

INITIAL CONNECTIONS