Installation Guide

FIGURE 1
FIGURE 2
Fig. 1
Fig. 2
4
1
2
3
Follow steps 1 and 2 of the Straight Rail Installation Instructions on page 2 to prepare the
area for installation.
Mark and cut the top and bottom rail to the desired angle.
NOTE: Fit the Left or Right Multi-Angle bracket onto the rail at the desired angle from the
end of rail to first baluster hole on both ends of the rail before cutting. Check end spacing
and shift the position of the rail before cutting if required. Ensure that the gap between
posts and balusters will not exceed 4”. (Fig. 1)
If the baluster interferes with the installation of the bracket, the top rail bracket may also
be installed on top of the rail instead of underneath the rail. (Fig. 2)
Complete installation by following steps 5 – 13 of the Straight Rail Installation Instructions
on pages 2 and 3.
horiZontallY anGleD rail installation