Product specifications

CashFlow
®
9520 / 9524 / 9528 Design Guide
©
MEI., 2003 Page 24 Rev: G1
Connector 4, Dynamic Route Inhibit
This input from the host machine to the front reject cover of the validator is known as the
Dynamic Route Inhibit. This inhibit signal indicates that a specific route has become full. To
Inhibit a route the relevant pin should be grounded (i.e. active low to inhibit a route).
Connector type used:- 9 pin SIL - AMP 925366.
Route Inhibit Connector
Pin No.
CF9528
8 Way Separator Exit Route
CF9524
4 Way Separator Exits
1 Route 1 Exit (d) = 1
2 Route 2 Exit (c )= 2
3 Route 3 Exit (a) = 3
4 Route 4 Exit (b) = 4
5 Route 5 Exit C = 5
6 Route 6 Exit D = 6
7 Route 7 Exit B = 7
8 Route 8 is the Default Exit A is the Default
9 Ground (0v) Ground (0v)
Note: Care must be taken to apply a Route full signal to the correct pin. For example of
Exit D is selected then the signal should be directed to Pin 6 (D). Likewise Pin 1 (d) should
be used of Primary Route (d) is selected.