Owner`s manual

Special Application Gold Mounts
UNI PAC
Consists of an Anton/Bauer Gold Mount with integral belt loops and a 5 ft.
power cable with a standard 4-pin XLR connector. The UniPac allows any Logic
Series Battery to power any piece of portable 12-17 volt accessory with a
standard 4-pin XLR DC input. Additionally, in cold climates or in tight spaces, the
UniPac allows the battery to be removed from the rear of the camera and worn
around waist or placed in some other appropriate place.
S O -14/28R
Available for universal applications, the SO-14/28R allows for any two Anton/
Bauer Logic Series Batteries to be used and has simultaneous 14.4V and 28V
(regulated) outputs.
· Simultaneous 14.4V and 28V (regulated) outputs
· 14.4V via 4p XLR (fused at 10 amps)
· 28V (regulated) via 3p XLR (fused at 12 amps)
· 28V output for all film cameras, tungsten, LED, and HMI lights, etc.
· 14.4V output for cameras, recorders, lighting, portable
microwaves, etc.
Q R - HOTSWAP- G M
Mounts directly to any Gold Mount for true perpetual, battery operation. Unlike
“stacking” batteries one behind the other, electronics in the QR-HOTSWAP-GM
allow for true “hot swapping” as either battery can be changed at any time.
Used with two batteries, the lightweight (13 oz/360g) QR-HOTSWAP-GM allows
for a maximum 248 watt hours of capacity and seamless, truly perpetual power.
QR-HOTSWAP-GM can be used with any combination of Anton/Bauer DIONIC
90, DIONIC HC, DIONIC HCX or HyTRON 50 batteries ONLY, due to the batteries’
sizes and weights.
Q R -QUAD- PT
Sandwich adapter with four PowerTap connectors allows you to power four
accessories, such as lighting, wireless receivers, hard drives, onboard monitors,
etc. Contains external replacement fuse. Maximum power draw is 10 amps.
QBH - HD
An accessory for the video/film dual voltage world which uses four of the same
type of Logic Series Batteries (the high power HyTRON 140/100 and DIONIC
160/HCX/HC are recommended). The QBH-HD will output both 14.4 and 28.8
Volts simultaneously-bridging the power gap between HD video cameras and
film accessories. The 28 volt output can handle HMI lighting as well as most
film cameras. QBH-HD is especially valuable in production environments where
equipment needs to operate for long periods of time or for extending operating
time of equipment at high current loads up to 10 amps.
· (3) 4p XLR outputs @ 14.4 volts and single 2-pin Amphenol output
@ 28.8 volts
· 10 amp external replaceable fuse
· Size: 4.6 x 12.3 x 2.6 in. (11.81 x 31.37 x 6.73 cm)
· Weight-2 lbs (.92kg)
SO-14/28R
UNIPAC
QR-HOTSWAP-GM
QR-QUAD-PT
QBH-HD shown with DIONIC HCX batteries