Measurement Guide

REPORT NO.: 85122610718
Form Owner: THD QA - Issue Date: 6/23/08 - Version #: 4
Proprietary & Confidential Page 2 of 29
The Home Depot Company Information
1. Product Requirements
1.1 GENERAL REQUIREMENT
Item# Item Qty
Style / Feature /
Finish / Color
Dimension /
Measurement
Tolerance Material
See
table 1
See table 1 1
WHITE, OAK,
BROWN, MAHOGANY
See table 1 For
dimension:
+/-5%;
For weight:
+/-10%
Metal,
Wood,
Plastic
1.2 PRE-PURCHASE TESTING RESULT
This product must
achieve a rating of
“Good” under The
Home Depot’s Pre-
Purchase Testing
Program or
“unsatisfactory” but
with THD’S PPT
Waiver.
PPT REPORT NO:
85122610718
85131490352
RATING:
Good;
Good with waiver
REMARK:
BST was waived by client.
1.3 PERFORMANCE TESTS
Test Property Test Requirement Comments
Full assembly Check
(For complex product
requires long time
assembly.)
The product should be assembled successfully according to
instruction sheet; also the product should function properly and
safely after assembly.
Nil
Load capacity
Shall Withstand distribute load at the following requirement. For
1 hours without permanent damage.
Rods up to 48 in: 15 lb
Rods over 48 in: load with ¼ lb per inch of length.
(Distribute the load across 50% of the rod length applied in the
middle of the rod while loaded)
Nil
Moisture Content Test
of natural wood
material only
The moisture content of wood product intended for indoor use
shall be within 4%-13%; The moisture content of wood product
intended for outdoor use shall be within 8% - 12%;
Nil
Coating Adhesion Test
on Coating / Painting
Component (if
available
1. Cross Hatching Test: Coated metal items shall be rated per
the scale specified in the standard when tested as appropriate.
Cut coating as specified, apply tape to cuts, then remove tape
after 2 min and examine for removal of coating from substrate.
Photograph if any plating / finish is removed. Select cutting
method as follows:
Use the cutter to make parallel cut so that space the
cuts 2mm apart and make six cuts: 6 lines (columns) x
6 lines (row) lead to 2mm x 2mm x 25 grids.
2. Tape Test: Coated nonmetallic component: press the adhesive
tape on coating / painting surface apply tape to cuts, remove tape
after 2 min and examine for removal of coating from substrate.
Nil