Use and Care Manual
10
4. Separate the dust tube from the inlet lter by rotating
clockwise to unlock (Fig. 10).
5. Use a mild soap and water solution to wash all the
housing components and rinse with clean water. Allow the
lters and housing to air dry for 24 hours before
re-installing.
Cleaning The Dust Tank
Clean the equipment routinely after each use:
1. Before all the inner housing components are re-installed,
empty the dust tank (Fig. 11). Clean the tank with water
and allow it to dry completely.
2. To re-assemble the inner housing components, lock the
dust tube by rotating counter-clockwise. Then place
all the components back into the dust tank in the order
shown (Fig. 12).
Fig. 9
Dust tank
Foam lter
Nylon mesh
Inlet lter
Dust tube
Multiple ltration
inlet lter
dust tube
Fig. 10
Fig. 11
Fig. 12
Dust tank
Foam lter
Nylon mesh
Inlet lter
Dust tube
Multiple ltration