Installation & Assembly

ASSEMBLY INSTRUCTIONS

Important Safety Instructions:

• For safety purpose, this lamp is equipped with a polarized plug (one blade is wider than the other). If the plug does

not fit securely into your outlet, do not force it, contact a professional electrician. Never alter the plug in any way.

• These instructions are provided for your safety. It is very important that they are read carefully and completely

before assembling fixture..

• This fixture has been rated for up to (1) 100-watt maximum TYPE A bulb or (1) 23-watt compact fluorescent

light bulb. To avoid the risk of fire, do not exceed the recommended wattage.

Pre-assembly:

 Do not discard any contents until after assembly is complete to avoid accidentally discarding small parts or

hardware.

 Remove all parts and hardware from box along with any plastic protective packaging.

Parts Enclosed:

Item Description QTY

A Shade 1pc

B Ring 1pc

Socket

1pc

Swing Arm

1pc

Long Pole

1pc

Long Pole

1pc

Lamp Base

1pc

Nut

1pc

Wrench

1pc

Cord

1pc

Warning:

 Wires and cables are all attached (further wiring is not needed from consumer). When unpacking product, be

careful to not pull wires as it may result as a bad connection. Do not plug into electrical outlet until lamp is fully

assembled.

Note:

Turn the power off (unplug from the wall outlet) before replacing the bulb. Make sure the bulb has sufficient time to cool

down.

Assembly Instruction:

Kenley Floor Lamp (item#MT154-0038)

PAGE 1
ASSEMBLY INSTRUCTIONS Kenley Floor Lamp (item#MT154-0038) Important Safety Instructions: • For safety purpose, this lamp is equipped with a polarized plug (one blade is wider than the other). If the plug does not fit securely into your outlet, do not force it, contact a professional electrician. Never alter the plug in any way. • These instructions are provided for your safety. It is very important that they are read carefully and completely before assembling fixture..
PAGE 2
Step1. Put the nut (H) through the cord (J) and lock into the base (G) and tighten by the wrench (I). Step2. Screw the long pole (F) onto the Base (G) while pulling cord (J) through long pole. Step3. Screw the long pole (E) onto the long pole (F). Step4. Screw the Swing Arm (D) onto the long pole (E). Step5. Put the lamp shade（A）on the lamp holder and locking the lamp ring (B). Step6. Assembly is completed.