User Manual

ManualsBrandsMartin Universal Design ManualsFurniture91-02609115 GRANDEUR CHAIRS

GRANDEUR Model’s

91-02606115 & 91-02609115

YOU WILL FEEL A SLIGHT

“BOUNCE-BACK” WHEN YOU SIT DOWN.

THIS IS NORMAL: NOT A DEFECT.

THE PNEUMATIC CYLINDER FOR THE

SEAT HEIGHT ADJUSTMENT REACTS

TO YOUR WEIGHT BY GIVING A LITTLE

IMPORTANT NOTICE

Assembled

92-02609115

Assembled

92-02606115

PARTS

A. [1] Base Plate Mechanism

B. [1] Cylinder

[a] 91-7706 model

[b] 91-7709 model

C. [5] Castors

D. [1] Plastic Ring insert

Model 92-02609 only

(This part can be found in

the foot ring Part F)

E. [1] 5-Star Base

F. [1] Foot ring with knob

Model 92-02606 only

H. [1] Seat

I. [1] Black Cylinder Bellows

Model 92-02609 only

IMPORTANT

If you have difﬁculty assembling your chair or need customer service assistance.

Please call: Martin Universal Design, Inc. Customer Service Hot Line at

1-313-895-0700. If you need additional parts, it is not necessary to contact your

dealer, our Customer Service Rep. will forward them to you immediately.

4444 Lawton Avenue, Detroit MI 48208 USA

Tel:(313)895-0700 • Fax:(313)895-0709

E-mail: Custservmud@aol.com

Visit us at: www.MartinUniversalDesign.com

J. [6] 1-1/8” Hex Head Screws

& [6] washers

K. [4] 1.5” Hex Head Screws

& [8] washers for Armrests

L. [4] 3/4”

Plastic Washers

for armrest attachment

G. [1] Backrest

M. [2] Armrests

Revised 03/2009 RPI

Summary of content (2 pages)

PAGE 1
IMPORTANT NOTICE YOU WILL FEEL A SLIGHT “BOUNCE-BACK” WHEN YOU SIT DOWN. THIS IS NORMAL: NOT A DEFECT. THE PNEUMATIC CYLINDER FOR THE SEAT HEIGHT ADJUSTMENT REACTS TO YOUR WEIGHT BY GIVING A LITTLE GRANDEUR Model’s 91-02606115 & 91-02609115 Assembled 92-02606115 Assembled 92-02609115 PARTS a. b. A. [1] Base Plate Mechanism D. [1] Plastic Ring insert Model 92-02609 only (This part can be found in the foot ring Part F) B. [1] Cylinder [a] 91-7706 model [b] 91-7709 model C. [5] Castors H. [1] Seat G.
PAGE 2
E 4. 7. Model # 92-02606 2. knob on foot ring weld Cut ends of plastic insert must run parallel with the weld. THIS STEP IS ONLY FOR MODEL 92-02606 ONLY. Before attaching foot ring (F) to cylinder (B). Begin by loosening the knob on the foot ring and make sure the plastic ringis inserted properly, by making sure the cut ends of the insert run parallel with the weld on the inside of the foot ring hole. The insert should be already in the foot ring.