Owner's Manual

6
INSTALLING THE ANTI TIP DEVICE
!
CAUTION
!
CAUTION
NOTE
Anti-Tip Device
If your refrigerator is not located under a counter top (free
standing), you must use an anti-tip device installed as
per these instructions. If the refrigerator is removed from
its location for any reason, make sure that the device is
properly engaged when you push the refrigerator back into
the original location. If the device is not properly engaged,
there is a risk of the refrigerator tipping over, causing prop-
erty or personal injury if you or a child stand, sit, or lean on
an open shelf.
If installing on a concrete oor, concrete fasteners are
required, (not included with the anti-tip kit).
Any nished ooring should be protected with appropriate
material to avoid damage when moving the unit.
Bottom View of
Refrigerator
Anti-Tip
Bracket
Leveling Leg
Front of cabinet
21
1
⁄2"
(54.6 cm)
Figure 6
Figure 5
Floor Mount Installation
The anti-tip bracket is to be located on the oor in the left or
right rear corner of the refrigerator as shown in Figure 6.
Step by step instructions for locating the
position of the bracket:
1) Decide where you want to place the refrigerator. Slide it
into place, being careful not to damage the oor, leaving 1"
(2.5 cm) of clearance from the rear wall to allow room for
the anti-tip bracket.
2) Raise the rear leveling legs approximately
1
⁄4" (6 mm) to
allow engagement with the anti-tip bracket. Level the unit
by adjusting all the leveling legs as required. Turning the
leveling leg counterclockwise will raise the unit and clock-
wise will lower the unit.
3) Make sure the refrigerator is in the desired location, then
mark on the oor the rear and side corner of the cabinet
where the anti-tip bracket will be installed. If the installation
does not allow marking the rear corner of the cabinet, then
make temporary lines on the oor marking the front corner
of the cabinet, excluding the door. Slide the refrigerator out
of the way. From the temporary line extend the sidewall line
back 21
1
⁄2" (54.6 cm) as shown in Figure 7.
4) Align the anti-tip bracket to the marks on the oor so
the side of the bracket lines up with the side of the cabinet
mark, and the "V" notches on the anti-tip bracket line up
with the end of the 21
1
⁄2" (54.6 cm) line (Rear of cabinet
line).
5) Fasten the anti-tip bracket to the oor using the supplied
screw. (See Figure 7).
6) Slide the cabinet back into position, making sure the rear
cabinet leveling leg slides under the anti-tip bracket engag-
ing the slot.