Owner's Guide

CLEANING YOUR ICE MACHINE
!
CAUTION
Forcing ice through the grid cutter will break the grid cutter
wires.
!
CAUTION
Remove all ice
from the evaporator
plate and grid cutter
area that is not
embedded in wires
Clean reminder:
CLEAN
NOTE
Homes with poor water quality or high clear ice usage
might require more frequent cleaning.
To clean your ice machine you will need to purchase a
"nickel safe" ice maker cleaner. Cleaner can be obtained by
contacting Marvel customer service at 616-754-5601
or email [e-mail].
Use only Marvel-approved ice machine cleaner and follow
all label warnings and directions. Incorrect chemical
usage, and any damage that may result, is not covered by
warranty.
Available to order
Clear Ice Machine Cleaner, 4-oz. bottle Part # S41013789
NOTE
For reference see our "Care and Cleaning video" at the
website: www.marvelrefrigeration.com.
Remove all ice from the ice bin.
Drain the water from the water reservoir by removing the
black plug from the bottom of the fresh water reservoir.
After the water is drained, replace the plug in the bottom of
the reservoir.
Allow all of the ice to fall from the evaporator plate
and remove any ice from the grid cutter. If there is ice
embedded in the grid cutter wires, wait for it to melt and
fall out. Do not try to remove ice that is embedded in
the grid cutter wires as that may break the wires.
OFF
When cleaning is needed, UI will alternate between "CL"
and "ICE" every 3000 cycles to indicate that the unit needs
to be cleaned. Over time, mineral buildup on the cold
evaporator plate can occur which can adversely
affect the quality of your ice. This build-up is dependent on
your water source and usage. Normal ice production will
continue while the "CLEAN" reminder is displayed. You
may clear the "CL" reminder at any time by holding "UP"
"DOWN" and "CLEAN" at the same time. When reset, the
"CLEAN" reminder will reset and not occur for another
3000 cycles. If you choose to clean the appliance at this
time, see the options menu section below.
Clean mode:
To ensure maximum performance and ice quality, it is
recommended to clean your ice machine once every six
months.
This simple cleaning routine will also ensure
water and energy use continues at optimum efficiency.
Once you have your cleaner:
Turn the ice machine off by pressing and holding the "ON/
OFF" icon for 3 seconds. "OFF" will be displayed on the
control.
16