Operating instructions

12 Masport I43 NEW YORK / ULTIMATE Gas Inbuilt Fireplace
INSTALLATION INSTRUCTIONS
7) The power cord should be run behind the faceplate panel.
8) Push the logo plate into the two holes in the bottom left
corner of the left side faceplate panel.
9) Secure the gold trim to the faceplate by drilling a
1/8" hole through into the faceplate side flange, using the
hole in the trim as a guide. Now fasten with the two brass
plated screws provided.
10) Lift the assembled face-
plate up and over the
top of the inbuilt and
then lower it down so
the faceplate
tabs are in line
with the face-
platebrackets.
See diagram 4. Once
everything is properly
lined up you can tighten
the 4 screws on the face-
plate brackets. See dia-
gram 5.
3) Using the trim clips provided,
join the left side gold trim (the
one with the ON/OFF switch
and FAN switch) to the top
gold trim. See diagram 2. Re-
peat this step for right side.
FACEPLATE & TRIM INSTALLATION
Diagram 4
Diagram 1
Diagram 2
Hint: Before doing the faceplace installation, leave the
inbuilt out approximately 4" so wires may be hooked
up easier.
1) Lay the faceplate panels flat, face down on something soft
so they don't scratch.
2) Take the top faceplate and align the holes in it with the
holes in the side panels. Attach, using the screws
provided. See diagram 1.
Note: The holes in the top panel are slightly larger
than the holes in the side panel to facilitate
easier installation.
Diagram 5
Diagram 3
4) Place the trim on the assembled faceplate panels, align-
ing the wires from the switches with
the notch in the left side faceplate
panel.
Hint: Don't tighten
the screws down
completely at this
point, first do a trial
fit to the unit. Make
any necessary
a djustments and
when it fits properly
then tighten down
the screws.
WARNING: The 3 wires are to the Fan and the 2 wires
are to the Burner ON/OFF switch. DO NOT connect
to the wrong switch.
Note: If you are making custom faceplates, you must use
the faceplate louvres. Failure to do so will void the
certification on your unit. The faceplate louvres can be
purchased separately, part #: 610-909.
5) FAN switch wires: Hookup the 3 Fan Switch wires to the
fan switch on the left side trim.
6) Burner ON/OFF wires: Hookup the 2 Burner ON/OFF
wires to the Burner switch on the left side trim. Diagram
3.