Operating instructions

13
Masport I43 NEW YORK / ULTIMATE Gas Inbuilt Fireplace
INSTALLATION INSTRUCTIONS
Diagram 2
Diagram 1
Diagram 3
BRICK PANEL INSTALLATION
1) Unwrap the brick pattern panels from the protective
wrapping.
2) Open the door and position the side brick panels into
place from the front of the firebox. There are two tabs to
the panels in place, on on each side. Carefully bend the
tabs down with a screwdriver until panels are held secure-
ly in place.
Note: Use caution when putting the side panels in as they
can easily be scratched by the hard component
parts.
LOG INSTALLATION
WARNING: Dangerous operating conditions may occur if
these logs are not positioned in their approved locations.
Read the instructions below carefully and refer to the
diagrams. If logs are broken do not use the unit until they
are replaced. Broken logs can interfere with the pilot and
burner operation.
The gas log kit contains the following:
a) Front Right Log - Part # 902-192
b) Front Left Log - Part # 902-193
c) Rear log - Part # 902-194
d) Embers - Part # 902-151 (1 bag)
(Part # 650-933 for the set of three logs)
1) Remove the logs from the box and carefully unwrap
them. The logs are fragile, handle with care - DO NOT
FORCE into position.
2) Place the rear log, carefully sliding it down onto the pins,
with the flat side of the log facing the back of the unit. See
diagram 1.
3) Place the left front log, carefully sliding it down onto the
left pins of the front burner. See diagram 2.
4) Place the right front log, carefully sliding it down onto the
right pins of the front burner. See diagram 3.
5) Distribute the embers along the front burner but do not
cover the burner ports and around the logs. See diagram
4.
Note: Do not force
logs down.
Diagram 4