Operating instructions

15
Masport I43 NEW YORK / ULTIMATE Gas Inbuilt Fireplace
INSTALLATION INSTRUCTIONS
OPTIONAL REMOTE CONTROL
Use the Masport Remote Control Kits approved for this unit.
Use of other systems may void your warranty.
The remote control kit comes with a hand held transmitter, a
receiver and a wall mounting plate.
1) Choose a convenient location on the wall to install the
receiver and the receptacle box (protection from extreme
heat is very important). Run wires from the fireplace to
that location. Use Thermostat Wire Table.
2) Connect the wires as per the wiring diagram on page 15.
CAUTION
Do not connect the millivolt remote
control wires to the 240V wires.
3) Install alkaline batteries in both the receiver and the
transmitter. Install the receiver and its cover in the wall.
Switch the hand held remote transmitter to "remote"
mode. The remote control is now ready for operation.
FINAL CHECK
Before leaving this unit with the customer, the installer must
ensure that the appliance is firing correctly. This includes:
1) Check operating pressure (see Data Badge for operating
pressure settings).
2) If required, adjusting the primary air to ensure that the flame
does not carbon. First allow the unit to burn for 15 min. to
stabilize.
Natural Gas: 8mm
Propane Full open
3) Check for proper draft.
CAUTION
Any alteration to the product that causes sooting or carbon-
ing that results in damage to the exterior facia is not the
responsibility of the manufacturer.
WIRING DIAGRAM