Operating instructions

21
Masport I43 NEW YORK / ULTIMATE Gas Inbuilt Fireplace
MAINTENANCE
FAN MAINTENANCE
If your fan requires maintenance or replacement, access to the
fan is through the access panel on the rear wall of the firebox.
NOTE: the unit MUST NOT be operated without the fan
access panel securely in place and correctly sealed.
IMPORTANT
Disconnect power supply before servicing
WARNING: Electrical Grounding Instructions
This appliance is equipped with a three pronged (ground-
ing) plug for your protection against shock hazard and
should be plugged directly into a properly grounded
three-prong receptacle. Do not cut or remove the ground-
ing prong from this plug.
To remove fan:
1) Unplug or disconnect power source to stove.
2) Remove all logs and the rear log support, then remove the
6 screws holding the access panel in place.
3) Disconnect white wire from fan to power cord.
4) Disconnect black wire from molex plug to thermodisc.
5) Unplug wire harness on left rear side panel (from inside
the stove).
6) Disconnect green ground wire from fan body.
7) Lift fan off of the 2 pins, tip forward and pull through
firebox opening.
Installing Glass
1) Install both center and side glass onto extrusions as per
diagram.
IMPORTANT:
These fans do collect a lot of dust from within your home.
Ensure you maintain these fan motors on a regular basis
by vacuuming out the fan squirrel cages.
Replacing fan:
Reverse abovesteps. Hint for pushing fan down onto pins - rub
a bit of dish soap on the grommet so it will slide more easily
onto the pin. Check to make sure the fan is seated properly on
the pins - try to move the fan back and forth, there should be
no noise, if there is check that the grommets haven't come
loose.
Caution: Ensure that the wires do not touch a hot surface.
2) Place glass assembly into door frame.
3) Install retainers by placing 1 drop of glue where previous-
ly glued and put in place.
4) Install side retainers.
5) Install door catch plate.
6) Install the 24 nuts loosely, do not tighten yet.
7) Tighten side panels nuts using the following procedure
:
a. tighten top & bottom outside corner nuts (2)
b. tighten inside nuts (3)
c. tighten top & bottom inside corners (2)
8) Tighten the 10 nuts on center glass retainer.
9) Repeat step 7 for other side panel.
10) Replace new gasket by gluing it in place.
11) Install door onto stove and check the seal.