Specifications

Masport In-built Fireplaces
10
Ontario
In-built Fireplace
(I2101M)
Vancouver
In-built Fireplace
(I3101L)
INSTALLATION
Diagram 1
C) ALL UNITS
Faceplate and Trim
Prior to sliding your insert into its final position and
attaching the connector or liner pipe, the faceplate must
be installed as follows:
1) Slide the spring nuts (supplied) over the slots in the
insert’s side convection panels (the spring nuts may
need to be squeezed with a pair of pliers first, to help
them stay in position).
2) Screw the side faceplate panels, (item A in the
diagram) one to each side.
3) Using the top panel (item B in the diagram) as a
gauge, check that the side panels are within
approximately 1/4" of the overall width. If the
difference is greater than this, use the
supplied washers to attain the required
width.
4) The unit may now be slid into final position and
attached to the connection system.
5) Once connection is made, the insulation strips
should be installed between the insert faceplates
and the fireplace face.
6) The faceplate top may now be installed (with
insulation strip behind) by aligning its brackets with
the top flange on the side shields and the angle iron
bar on the insert top.
7) The faceplate trim may be installed to the edge of
the faceplate at this time. To permanently mount the
trim, drill two 5/32" diameter holes through the trim
and side panels and screw the trim to the panels
using the gold plated screws provided.
Note: It may be easier to install the insulation,
faceplate top and faceplate trim with the unit pulled
slightly away from the fireplace face. If this is done,
be very careful not to disturb the connector when
shifting the unit to its final position.
8) Now that your insert is installed, check once more
that all the clearances from the unit to any combustible
materials are correct as listed earlier.
.
Floor Protection
Please check to ensure that your floor protection and
hearth will meet the standards for clearance to
combustibles. Your hearth extension must be made
from a non-combustible material.
Firebrick Assembly
Firebrick is included to extend the life of your in-built
fireplace and radiate heat more evenly.
Check to see that all firebricks are in
their correct positions and have
not become misaligned
during shipping.