Use and Care Manual

OWNER’S/OPERATOR’S
MANUAL
07.0
16. MAINTENANCE
16- 23
STORAGE TIPS
CAUTION
Do not start the engine during the storage period. This will disturb the
protective film created by fogging.
Cleaning
——
Clean the UTV thoroughly.
Fuel
——
drain the carburetor bowl completely.
Oil Add and Filter Change
——
Warm the engine and change oil and
filter.
Air Filter/Air Box
——
Inspect and clean or replace the pre-cleaner and
air filter. Clean the air box and drain the sediment tube.
Inspect All Fluid Levels
——
Inspect the following fluid levels and
change if necessary: transmission; brake fluid (change every two years
or as required if fluid looks dark or contaminated).
Fog the Engine
——
Spray a light oil into the cylinder through the spark
plug hole.
Check and Lubricate Cables/Grease
——
Inspect all cables and
lubricate.
Battery Maintenance
——
Remove the battery and add distilled water
as required to the proper level. Do not use tap water which may contain
minerals that reduce battery life. Apply Dielectric Grease to the terminal
bolts and terminals. Charge the battery.
Storage Area/Covers
——
Set tire pressure and safely support the UTV
with the tires 1-2
‖
(25-50mm) off the ground. Be sure the storage area is
well ventilated. Cover the machine with a UTV cover.
NOTE: Do not use plastic or coated materials. They do not allow
enough ventilation to prevent condensation, and may promote
corrosion and oxidation.
TRANSPORTING
Whenever the UTV is to be transported the following measures should
be taken.
1. Turn off the engine and remove the key.
2. Be certain the fuel cap, oil cap, and seat are installed correctly.