Use and Care Manual

OWNER’S/OPERATOR’S
MANUAL
07.0
16. MAINTENANCE
16- 19
Do not use improper tires. The use of non-standard size or type tires
may affect UTV handling.
Make certain the wheels are installed properly. If wheels are improperly
installed it could affect vehicle handling and tire wear.
Tire Pressure
front rear
70kPa/10PSI 100kPa/14PSI
Wheel Removal Procedure
1. Stop the engine, place the transmission in gear and lock the parking
brake.
2. Loosen the wheel nuts slightly.
3. Elevate the side of the vehicle by placing a suitable stand under the
footrest frame.
4. Remove the wheel nuts and remove the wheel.
Wheel Installation
1. With the transmission in gear and the parking brake locked, place th
wheel in the correct position on the wheel hub. Be sure the valve stem
is toward the outside and totation arrows on the tire point toward
forward rotation.
2. Attach the wheel nuts and finger
tighten them.
3. Lower the vehicle to the ground.
4. Securely tighten the wheel nuts
according to the chart found in
―
16.MAINTENANCE/ Wheel Nut
Torque
‖
.
Tire Inspection
When replacing a tire always use original equipment size and type.
Tire Tread Depth
Always replace tires when tread depth is worn
to 1/8
‖
(3mm) (1) or less. Please refer to your
Owner
’
s Manual for tire specifications.