Use and Care Manual

OWNER’S/OPERATOR’S
MANUAL
07.0
16. MAINTENANCE
16- 21
1. Remove the screws
①
.
2. Remove the lens
②
.
3. Remove bulb and replace it with recommended bulb.
4. Test the taillight/ brakelight to see that it
’
s working .
5. Reinstall the lens and screws.
High Beam Headlight Adjustment
The headlight beam can be adjusted up and down.
1. Place the vehicle on a
level surface with the headlight
approximately 10
’’
(3m) from a wall.
2. Measure the distance from the
floor to the center of the headlight
and make a mark on the wall at the
same height.
3. Start the engine and turn the headlight switch to high beam.
4. Observe headlight aim. The most intense part of the headlight beam
should be aimed 2.8
’’
(71mm) below the mark placed on the wall in
step 2.
NOTE :
Driving weight must be included on the seat.
5. To turn the two adjusting screws
③
clockwise is to lower the beam
area and
to turn the two adjusting screws
③
counterclockwise is to heighten
the beam area.
CLEANING YOUR UTV
Keeping your UTV clean will extend the life of various components.
Washing
Never use a high pressure type car wash system, it can damage to the
wheel bearings, transmission seals, body panels, brakes and warning
labels, and water might enter the engine or exhaust system.
The best and safest way to clean your UTV is with a garden hose and a
pail of mild soap and water. Use a professional type washing mitten,
cleaning the upper body first and lower parts last. Rinse with
water frequently and dry with a chamois to prevent water spots.
NOTE:
If warning labels are damaged, contact your dealer for replacement.