Use and Care Manual

T-Boss410 OWNER’S/OPERATOR’S MANUAL 18.0
16. MAINTENANCE
16- 23
Rear Gear case Lubrication
CAUTION
Be sure no foreign material enters the gear case.
Which the ATV on the a level surface, remove fill plug and visually
inspect the lubricant level through
the fill hole(1).Lubricant should be
kept even with the center of the drill
point approximately
below the top of the fill hole.
NOTE: Do not add lubricant to the
bottom of the fill plug threads. The correct gearcase lubricant to use is
SAE 80W/90 GL5 Weight Gear Lube.
Oil Changing Procedure
1. Remove drain plug (2). Catch and
discard used oil properly.
2. Clean and reinstall the drain plug
with a new sealing washer and
tighten securely (14 ft. lbs/20N.m).
3. Remove fill plug and add 6.7 ounces
(200ml) of SAE 80W/90 GL5. Weight
Gear Lubricant and inspect oil level. Oil level should be kept even with
the center of the drill point (approximately below the top of the fill hole).
4. Reinstall the fill plug. Tight securely (24.5 ft. lbs/35N.m).
5. Check for leaks.