Use and Care Manual

T-Boss410 OWNER’S/OPERATOR’S MANUAL 18.0
16. MAINTENANCE
16- 24
Front Gear case Lubrication
CAUTION
Be sure no foreign material enters the gear case.
With the UTV on a level surface, remove fill plug and visually inspect
the lubricant level through the fill hole. Lubricant should be kept even
with the center of the drill point approximately below the top of the fill
hole.
NOTE: Do not add lubricant to the bottom of the fill plug threads. The
correct gear case lubricant to use is SAE GL-4 85W/90 Weight Gear
Lube.
Oil Changing Procedure
1. Remove the drain plug. Catch and discard used oil properly.
2. Clean and reinstall the drain plug with a new sealing washer and
tighten securely (14.8 ft. lbs/20N.m).