Use and Care Manual

T-Boss410 OWNER’S/OPERATOR’S MANUAL 18.0
16. MAINTENANCE
16- 28
Waxing
Your UTV can be waxed with any non-abrasive automotive paste wax.
Avoid the use of harsh cleaners since they can scratch the body finish.
CAUTION
Certain products, including insect repellants and chemicals, will
damage plastic surfaces. Care must be taken when using these
products plastic surfaces.
STORAGE TIPS
CAUTION
Do not start the engine during the storage period. This will disturb the
protective film created by fogging.
Cleaning——Clean the UTV thoroughly.
Oil Add and Filter Change——Warm the engine and change oil and
filter.
Air Filter/Air Box——Inspect and clean or replace the pre-cleaner and
air filter. Clean the air box and drain the sediment tube.
Inspect All Fluid Levels——Inspect the following fluid levels and
change if necessary: transmission; brake fluid (change every two years
or as required if fluid looks dark or contaminated).
Fog the Engine——Spray a light oil into the cylinder through the spark
plug hole.
Check and Lubricate Cables/Grease——Inspect all cables and
lubricate.
Battery Maintenance——Remove the battery and add distilled water
as required to the proper level. Do not use tap water which may contain
minerals that reduce battery life. Apply Dielectric Grease to the terminal
bolts and terminals. Charge the battery.
Storage Area/Covers——Set tire pressure and safely support the UTV
with the tires 1-2”(25-50mm) off the ground. Be sure the storage area is
well ventilated. Cover the machine with a UTV cover.
NOTE: Do not use plastic or coated materials. They do not allow
enough ventilation to prevent condensation, and may promote
corrosion and oxidation.
TRANSPORTING