Use and Care Manual

T-Boss410 OWNER’S/OPERATOR’S MANUAL 18.0
13. CVT SYSTEM
13- 1
WARNING
The CVT system rotates at high speeds. Creating large amounts of
force on clutch components.
Do not modify any components of the CVT system. Any modification will
damage the system; cause the system to be out of balance,
The CVT housing must be securely in place during operation,
Failure to comply with this warning can result in severe injury or
death.
CVT SYSTEM
On UTV, the approximate gear ratio difference between high and low
range is 1:2.05.This difference in gearing affects the operation of the
CVT, especially at speeds less than 7 MPH, due to the system’s
dependence on engine speed.
By switching to low range while operating at low ground speeds, the air
temperature in the clutch will be reduced. Reducing the temperature
inside the clutch cover extends the life of the CVT components (belt,
cover, etc.).
Adjust the center distance of the CVT :
1. Remove crankcase filter cover, cover protector and crankcase
cover.
2. Loosen the left link bolts③, right link bolts② and engine mounting
bolts ①.
3. Adjust the supporting bolt and measure the size L,D;
4. Tighten the engine mounting bolts ①, right link bolts ②and left link
bolts③;
5. Install crankcase filter cover, cover protector and crankcase cover.
NOTE:
1. Never operate the engine when adjusting the CVT;
2. The adjustment of the CVT must be done by your dealer.