Use and Care Manual

T-Boss550 OWNER’S/OPERATOR’S MANUAL 18.0
7. CONTROL AND PARTS FUNCTIONS
7- 2
reverse.
Do not switch on 4WD if the rear wheels are spinning. This may
cause severe machine damage. When switch on 4WD, the button
will stay in 4WD position but 4WD mechanics maybe still
disengaged. Always apply throttle gently and let the wheels move
slightly to allow the 4WD mechanics finally engage. The 4WD
indicator on the speedometer will come on when 4WD engaged.
2. Turn Signal Lamp Switch
4. Main Switch
Functions of the respective switch positions are as follows:
ON: All electrical circuits are supplied with power.
OFF: All electrical circuits are switched off. The key can be removed
in this position.
START: The electric starter is engaged by turning and holding the
key in this position. Release the key when the engine
starts.
Do not operate the electric starter continuously for more than 5
seconds, or starter damage could occur. Wait at least 5 seconds
between each operation of the electric starter to let it cool.
Do not turn the key to the “START” position with the engine running,
or damage to the electric starter can result.
5. Hi/ Lo Beam Switch
Turn on the high-beam headlight
Use caution and drive at reduced speeds in conditions of reduced
visibility such as fog, rain and darkness.
6. Rear Diff Lock Switch
When in 2WD, the switch can change rear diff lock or rear diff
unlocked. When in 4WD, the switch can not work, the vehicle will stay
rear diff lock.