Use and Care Manual

T-Boss550 OWNER’S/OPERATOR’S MANUAL 18.0
16. MAINTENANCE
16- 9
WHEEL NUT TORQUE SPECIFICATIONS
Bolt Size
Specification
Front M10X1.25
63Ft.Lbs
85N.m
Rear M10X1.25
63Ft.Lbs
85N.m
NOTE: All nuts that have a cotter pin installed must be serviced by
an authorized Dealer.
Front Wheel Hub Tightening
Front wheel bearing tightness and spindle nut retention are critical
component operations. Service work must be performed by an
authorized dealer.
Front Rear
Tapered nuts: install with
tapered side against wheel
AXLE BOOTS
●Rear Prop Shaft Boots,
●Front Axle (CV Joints, 4x4 model) Boots,
Check the protective boots for holes or tears. If any damage is found,
have them replaced by an authorized dealer.