Instructions / Assembly

SOLAR MOTOR REPLACEMENT

TOOLS REQUIRED

7/16” Socket Wrench

7/16” Nut Driver

4mm Allen Wrench

Pliers

MOTOR_REPLACEMENT

***CAUTION: To avoid injury the solar panel must be covered before replacing motor ***

1. Disconnect the plug in connector between the solar panel and motor.

The connector can be found close to the motor inside the attic.

2. From inside attic, loosen the fan blade assembly on the motor shaft by

using a 4mm Allen wrench to loosen the set screw found on the hub of the

blade.

3. Loosen the 7/16” nuts that hold the motor in the motor bracket. Be sure to keep support under

the motor to prevent it from falling out of the brackets. Carefully slide the motor out of the

motor bracket. Let the fan blade rest on the motor brackets.

4. Place the new motor into the motor bracket. Slide the fan blade

over the motor shaft. Tighten the 7/16” bolts. Position fan

blade so the set screw is lined up with the flat part of the motor

shaft. Top of blade should be flush with the top of the motor

shaft. Tighten 4mm set screw.

5. Reconnect the plug in connector between the solar panel and

motor. This connector can be found close o the motor inside

the attic

6. Remove cover from solar panel

PAGE 1
SOLAR MOTOR REPLACEMENT TOOLS REQUIRED 7/16” Socket Wrench 7/16” Nut Driver 4mm Allen Wrench Pliers MOTOR_REPLACEMENT ***CAUTION: To avoid injury the solar panel must be covered before replacing motor *** 1. Disconnect the plug in connector between the solar panel and motor. The connector can be found close to the motor inside the attic. 2. From inside attic, loosen the fan blade assembly on the motor shaft by using a 4mm Allen wrench to loosen the set screw found on the hub of the blade. 3.
PAGE 2