Use and Care Guide

OPERATING INSTRUCTIONS

Grill Lighting Instructions

To Light the Main Burners and the Side Burner

1. Make sure the control knobs are in the “OFF” position.

2. Open the grill hood.

3. Check the ignition pin position and distance between the pin

and the burner.

4. Make sure the drip tray is installed.

5. Open the LPG tank or natural gas valve.

6. Light each burner separately. Turning on two burner valves

together could trip the flow limiting device in the tank

connection ( LP grills only).

7. Push the control knob in and turn the knob to the left to “HIGH” position.

8. Push and turn burner control knob to “HIGH” and immediately press and hold

electronic igniter.

9. If the burner does not ignite within 5 seconds, immediately turn the control knob

back to the “OFF” position. Wait 5 minutes and repeat step 7 two or three times.

10. If the burner still does not ignite, TURN OFF THE GAS. WAIT 5 MINUITES for

excess gas to dissipate.

11. If the burner still can’t be lit, refer to the Troubleshooting section.

Replacing the Battery

1. Unscrew the electrical ignition button and remove the old battery.

2. Replace with a new AA battery.

WARNING:

1. Make sure the hood is completely open each time you attempt to light the grill.

Failure to open the hood could lead to delayed ignition resulting in bodily harm.

2. This grill is equipped with a flame observation hole in the side panel.

CAUTION: It is important to inspect the full length of the gas line hose. If it is evident

there is excessive abrasion or wear, or the hose is cut, the hose must be replaced prior

to the appliance being used.

If required, check your parts list for the proper replacement hose assembly.

Note: The negative (-) side of the battery goes in first. Please refer to the mark on

the side of the cap.

lowes.com/masterforge