Use and Care Guide

OPERATING INSTRUCTIONS
22
Match Lighting Instructions
IMPORTANT: The hood must be open when match lighting any burner.
1. Turn on gas supply.
a. If portable, at the LP cylinder valve.
b. If permanent gas supply, at the manual gas shutoff valve.
2. Locate the flame observation holes on each side
.
3. Access the match clip with chain.
4. Attach either the match or paper to the clip (Fig. 26), light the match and insert it close to
the ports of the burner, and push and turn the depressed knob to the left to “HIGH” position.
Fig. 26 Match/Paper Lighting Illustration
5. The center burner (if needed) can be lit from center grid by inserting the match clip into the
front side of flame tamer. Light this burner before igniting both outside burners.
6. Depress burner valve for that burner and turn to “HIGH”.
7. Observe that the burner has ignited. Remove the match and extinguish.
8. Repeat steps 2-6 for the next burner.
Breaking in Your Grill
When firing your grill for the first time, it is advisable to run the main burner(s) on “HIGH” for
20 minutes with the hood down and then turn the main burners off. This tempers the grill.
LOW
OFF
IGNITE / High
lowes.com/masterforge
®