Use and Care Guide

CARE AND MAINTENANCE

WARNING

Do not attempt to turn off the LP tank valve without first covering your hand

with a protective mitt or allowing the grill to cool down. Failure to follow this warning

could result in a severe burn.

LP Gas Safety Requirements

For LP gas grills, the LP gas supply tank to be used must be: Constructed and marked in

accordance with the Specifications for LP Gas Tanks of the U.S. Department of

Transportation (DOT) or the National Standard of Canada, CAN/CSA-B339 Cylinders,

Spheres and Tubes for Transportation of Dangerous Goods; and Commission, as applicable;

and Provided with a listed Overfill Prevention Device (OPD).

The tank should be 12 in. in diameter and 18-1/2 in. tall and be equipped with a

Type-I fitting.

The tank supply system must be arranged for vapor withdrawal.

The tank used must include a collar to protect the cylinder valve.

Do not operate the gas grill indoors or in any enclosed area. If the gas grill is not in use, the

gas must be turned off at the supply tank. If the grill is to be stored indoors, disconnect the

gas supply tank and store the tank in an upright position in a cool, well-ventilated outdoor

location away from your grill or any other heat source.

When checking for gas leaks, do not use an open flame. Use a soapy water solution and

apply it to the pipe joints and fittings with a brush and check for bubbles. Check flexible hoses

for cuts and wear that may affect the safe operation of the grill. Only the factory supplied hose

and regulator must be used. Use only replacement regulator and hose assemblies specified

by manufacturer.

LP tank should be securely locked by the safety tank ring at all times. An unlocked

tank may fall or tilt which can cause injury or property damage. It is recommended to lock the

tank all the time.

After positioning the tank in the opening, lower the safety

tank ring to lock the tank. Use only a 20 lb. gas tank.

WARNING

The pressure regulator and hose assembly supplied with the outdoor cooking gas

appliance must be used. Replacement pressure regulators and hose assemblies must

be those specified by the outdoor cooking gas appliance manufacturer.