Use and Care Guide

ASSEMBLY INSTRUCTIONS
11
Lowes.com/masterfor
g
e
5. Align the holes in the Center Panel (K)
with the holes in the main bottom panel (S)
and insert the screws (BB) into the
aligned holes and tighten them. (Fig. 5)
Note: Do not tighten the screws completely.
Leave at least one full turn on each.
6. For right rear panel (J), there are four
screws (BB) to connect to the left rear panel (I)
and main bottom panel (S), three in the rear
and one inside the cabinet. Insert the screws
into the aligned holes. After all the screws
have been installed, tighten the three screws
installed during step 5 and the one inside the
cabinet first, and then tighten the three in the
rear. (Fig. 6)
Hardware Used
1/4-20 x 5/8 in.
Screw
X 3
BB
Hardware Used
1/4-20 x 5/8 in.
Screw
X 4
BB
5
K
S BB
6
J
BB
I
S