Use and Care Guide

COOKING WITH GAS

Lowes.com/masterfor

For Natural Gas Connection

Preparing:

1. Turn off gas supply, and then remove cap on gas supply side.

2. Recommended: Install a shut-off valve on gas supply side before installing the socket.

3. Socket should be installed by an authorized technician in accordance with the national

fuel gas code (NFPA 54/ANSI223.1).

4. Before inserting plug, turn on gas supply and leak test all connections including the stem

of the shut-off valve and the opening of the socket. For best results, use an

ammonia-free soap and water solution.

Operating Instructions:

1. To connect, push back socket sleeve (Fig. 31).

2. Insert plug and release sleeve (Fig. 32).

3. Push plug until sleeve snaps forward (Fig. 33).

(Gas will flow automatically. Failure to connect

plug properly to socket will inhibit gas flow to

the appliance.)

Fig. 33

4. Test connection with ammonia-free soap and water solution.

To disconnect

1. Pull sleeve back. Pull plug out of socket. (Gas is automatically shut off.)

2. Close shut-off valve and replace dust caps on socket and plug.

Gas Requirements

The 3218LTN grill is set and tested at the factory for the type of gas supply to be used.

Identify the type of gas, either natural gas or LP gas, and make sure the marking on the rating

plate matches the gas supply. The rating plate is located on the inside panel of the left door.

Sleeve

Socket

Plug

Socket

Sleeve

Fig. 31

Sleeve

Socket

Fig. 32