Use and Care Guide

11
Lowes.com/masterforge
ASSEMBLY INSTRUCTIONS
5. Slide the tank ring bracket (K) onto the end
of the safety tank ring (J) as shown. Attach
the tank ring bracket to the rear panel (L)
with 2 screws (BB) as shown.
6. Attach the drip tray support (I) to the front
beam (U) and rear panel (L) with 4 screws
(AA) as shown.
7. Remove the cap and the nut from the igniter
(M). Secure the igniter to the right panel (N)
with the nut. Then, reassemble the cap to
the igniter.
Hardware Used
AA
3/16-24 x 1/2 in.
Screw
x 4
Hardware Used
1/4 - 20x 5/8 in.
Screw
x 2
5
BB
BB
K
J
6
AA
U
I
7
Nut Cap
M